Loading ...
Loading ...
Loading ...
25
Installation
There must be a safety distance between the hot-
plate of the cooking pot on the hob and the bottom
part of the cooker hood:
The distance must be between 60 – 75 cm. For gas
appliances, the distance must be at least 65 cm. If
the installation instructions for the gas cooker specify
a greater distance, this distance must be taken into
consideration.
Selecting the fume outlet
You can operate the cooker hood in two modes:
Extraction mode
WARNING:
• The extracted air may not be vented into a flue
which is used for the waste gas from appliances
which are powered by gas or other fuels.
• When venting the extracted air, comply with the
regulations of the relevant local authorities.
The hood has an upper air outlet to vent cooking
odours to the outside.
The extracted air is normally vented
vertically. The extracted air can vented
through the wall units and the loft floor
to the roof ridge.
If there is a conduit under the wall units,
the extraction duct can be routed so that
the extracted air can be vented horizon-
tally through the wall.
Recirculation mode
If you do not have a direct extraction vent to the out-
side; the hood can also work in recirculation mode
(i.e. without an extraction vent to the outside; the
filtered air is released back into the room). In this
case, an activated carbon filter as described under
“ Installing the activated carbon filter for recirculation
mode”, must be used.
For the model ONTARIO635X, you can order the
carbon filter CFC1023 from your dealer. For
the models VOSTOK960X/B/W,
VOSTOK760X/B/W, VOSTOK660X/B/W the
carbon filter comes within the carton box.
Assembly
WARNING:
• When assembling or inserting the extraction filter
as well as the carbon filter, the appliance must not
be connected to the power supply.
• Failure to use the mounting fixtures may lead to a
risk of electric shock.
CAUTION:
• Before mounting, check that the wall has sufficient
load capacity to bear the cooker hood.
• When drilling the holes in the wall always make
sure that no existing electrical cables or other ob-
jects are damaged.
• Make sure that the ventilation slots are clear of
obstacles and are not covered.
NOTE: Recommendations for preparation work
• When installing, ask another person to assist.
• Wear protective gloves to prevent injuries from
any sharp edges.
• Determine the position of the cooker hood central-
ly above the hob in conformance with the speci-
fied safety distances.
• Align the drilling template and mark the necessary
holes for the wall mounting. Check them with a
spirit level.
Drill mounting holes 4 x Ø8 mm and insert the
dowel pins.
•
Loading ...
Loading ...
Loading ...