Loading ...
Loading ...
Loading ...
UP
Press to raise (warm) the set temperature by
1
°C or 1°F.
DOWN
Press to lower (cool) the set temperature by
1
°C or 1°F.
°F/°C Selector
Select the temperature display setting in Fahrenheit or Celsius degree. To change the temperature from
Fahrenheit to Celsius or from Celsius to Fahrenheit, touch and hold mark for 5 seconds.
TEMPERATURE ZONES
The wine cooler has two temperature zones with a temperature range of 40-64°F. The recommended temperature
setting for each zone is:
• Lower Zone between 55-64°F (Ideal for red and white wines)
• Upper Zone between 40-55°F (Ideal for sparkling and white wines)
NOTE: The temperature set for the Lower Zone must always be the same or higher than the temperature set for the
Upper Zone. For optimal performance, the set temperature of the two zones should differ by at least 4°F.
SETTING A TEMPERATURE
• Touch SET to set the internal temperature for each zone. The degrees indicators will appear in the
display window marked for UPPER ZONE and for LOWER ZONE.
• When you touch SET for the first time, the LED readouts will show the original temperature settings
(preset factory setting for UPPER ZONE is 50°F / 10°C and for LOWER ZONE is 60°F / 16°C).
• Touch SET once. The left LED indicator for UPPER ZONE will flash. Then touch UP or DOWN
to set the desired temperature.
• When you touch SET again, the right LED indicator for LOWER ZONE will flash. Then proceed to
touch the UP or DOWN to set the desired temperature for the LOWER ZONE.
• The temperature will increase by
1
°C or 1°F if you touch UP once, or the temperature will decrease
by
1
°C or 1°F if you touch DOWN once.
• To view the set temperature in either zone at any time, touch UP or DOWN and the set
temperature will temporarily flash in the LED display for 5 seconds. You can touch SET to view the
temperature setting from one zone to the second zone.
NOTE: When using the unit for the first time or after a long period of inactivity, there may be a variance of a few degrees
between the selected temperature and the temperature indicated on the LED readout. This is normal due to the length of
inactivity, and will correct itself after the unit is run for a few hours. If the unit is unplugged, has lost power or is turned off,
wait 3 to 5 minutes before restarting the unit. The unit will not restart before this time delay.
10
0
Loading ...
Loading ...
Loading ...