Loading ...
Loading ...
Loading ...
EN - 12
• Use hot running water to clean all of the
components of the milk system (13) and the
tube (24) and dry them thoroughly.
• Assemble the various parts and reassemble
the milk system (13). Ensure that the milk
system (13) is correctly mounted in all of
its parts. Check the numbering in Fig. “H”.
• Fix the milk system (13) in the dispenser (11),
by pressing it rmly.
• Lastly, reassemble the dispenser lid (14).
Do not wash the milk system in
the dishwasher not to damage it
permanently.
• Automatic cleaning via the ‘Easy
Cleaning’ key
Proceed as follows to start the Easy Cleaning
procedure.
• Fix the cleaning container (28) onto the cup
grid (21)
• Fill the cleaning container (28) with cool
water up to the mark indicated
• Connect the milk tube (24) to the coffee
machine as described in the “Connecting
the milk tube” section and immerse it inside
the tray through the relevant compartment,
as shown in gure I
• Hold the Easy Cleaning key (35) down for
3 seconds to start complete cleaning of the
milk circuit.
• The machine runs a thorough cleaning
cycle of the milk tube (24), milk system, milk
dispensing nozzle (13).
• The cycle stops on completion.
The milk system (13) and all the
components (14, 15, 16, 24)
can be washed using detergent
suitable for cleaning domestic
coffee machines.
If proceeding in this manner,
make sure that all components
have been rinsed well before
re-assembling them (in the case
of manual washing) or repeat an
‘Easy cleaning’ cycle to remove any
residual detergent.
Fast cleaning of the circuits
• It is possible to start a quick rinse cycle at
any moment.
• The key lights up steady at the end of the
washing cycle.
Cleaning the brewing group (22)
We recommend cleaning the
brewing group at least once a
week.
• The coffee machine indicates when brewing
group cleaning is recommended (steady lit
LED 40).
• With the machine on, press the lower part
of the door (8) until it is released and slide
it out from the top.
• Press the two release clips (44) located on
the sides of the infuser (22) and remove it
from the machine
(Fig.L).
• Wash the brewing group (22) with running
water and dry it.
• Thoroughly clean its housing and the duct as
well, using the cleaning brush (25) supplied,
as in Figure “L”.
• Dry thoroughly before re-mounting the
various components.
• Ret the service door (8) making sure it is
correctly positioned.
Cleaning and maintenance
Loading ...
Loading ...
Loading ...