Vevor STL-1908 Dog Dryer, 2000W/2.7HP Dog Blow Dryer, Pet Grooming Dryer with Adjustable

Manual - Page 4

For STL-1908.

PDF File Manual, 12 pages, Read Online | Download pdf file

STL-1908 photo
Loading ...
Loading ...
Loading ...
2
IMPORTANT SAFEGUARDS
Before using, please read this manual and always
comply with basic precautions when using it. Once the
product is used, you acknowledge that you have
carefully read and accepted the following safety instructions.
Danger! Electric shock due to damage of appliance.
Do not operate the appliance with a broken cord or plug or if the
appliance malfunctions,or is dropped or damaged in anyway.
Always unplug the unit when not in use or left unattended. Do not wrap
the cord around the appliance.
Never carry the unit by its power cord.
Do not drop or insert any object into any opening.
We do not recommend using the built-in heater during the summer
months.The heated airflow may damage your pets hair and skin.
If however,the airflow is inadvertently obstructed during use,the builtin
thermal safety device will automatically cut out the appliance.This dryer will
switch on again automatically after cooling down for a few minutes.
Please be sure to keep the air intake at the rear of the unit clear of debris
or blockage.Lack of proper airflow will damage the unit's motor and impact
product's life.
If there happens to be a fault with the motor,the power light will illuminate
but no airflow will be produced. Immediately turnoff the heater as continued
use without airflow may result in a fire.
When the pet dryer is used in a bathroom, unplug it after use since the
proximity of water presents a hazard even when the hairdryer is switched
off.
For additional protectionthe installation of a residual current
device(RCD) having a rated residual operating current not exceeding
30mAis advisable in the electrical circuit supplying the bathroom. Ask your
installer for advice. (NOTE: Mains sockets might not be permitted in
average sized bathrooms according to local wiring regulations.)
If the supply cord is damaged, it must be replaced by the manufacturer,
its service agent or similarly qualified persons in order to avoid a hazard.
Loading ...
Loading ...
Loading ...