Loading ...
Loading ...
Loading ...
332
39.3.2 Enabling/Disabling Sending of SNMP Traps on a Port
From the SNMP > Trap Group screen, click Port to view the screen as shown. Use this screen to
set whether a trap received on the port(s) would be sent to the SNMP manager.
Figure 235 Management > Access Control > SNMP > Trap Group > Port
The following table describes the labels in this screen.
Options Select the individual SNMP traps that the Switch is to send to the SNMP station. See SNMP
Traps on page 340 for individual trap descriptions.
The traps are grouped by category. Selecting a category automatically selects all of the
category’s traps. Clear the check boxes for individual traps that you do not want the
Switch to send to the SNMP station. Clearing a category’s check box automatically clears
all of the category’s trap check boxes (the Switch only sends traps from selected
categories).
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 162 Management > Access Control > SNMP > Trap Group (continued) (continued)
LABEL DESCRIPTION
Table 163 Management > Access Control > SNMP > Trap Group > Port
LABEL DESCRIPTION
Option Select the trap type you want to configure here.
Port This field displays a port number.
Loading ...
Loading ...
Loading ...