Maxx Cold MXSPP92 HC 94" Select Series Pizza Preparation Table with 30.87 cu. ft. Capacity, Casters, Forced Air Refrigeration System and Adjustable Epoxy Coated Shelves in Stainless Steel

User Manual - Page 10

For MXSPP92.

PDF File Manual, 19 pages, Read Online | Download pdf file

MXSPP92 photo
Loading ...
Loading ...
Loading ...
Page 10 of 19
APPLIANCE INSTALLATION
Remove Packaging Materials
IMPORTANT:
Do not remove any permanent instruction labels or the data label on your appliance.
Remove tape and glue from your appliance before using.
To remove any remaining tape or glue, rub the area briskly with your thumb. Tape or glue residue can also be
easily removed by rubbing a small amount of liquid dish soap over the adhesive with your fingers. Wipe with
warm water and dry with a soft cloth.
Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue.
These products can damage the surface of your appliance.
NOTICE:
LOSS OR SPOILAGE OF PRODUCTS IN YOUR APPLIANCE IS NOT COVERED BY WARRANTY. IN ADDITION TO
FOLLOWING RECOMMENDED INSTALLATION PROCEDURES. PLEASE RUN THE APPLIANCE 24 HOURS PRIOR
TO USAGE.
Location Requirements
Appliances represented in this manual are intended for indoor use only.
Be sure the location chosen has a floor strong enough to support the total weight of the cabinet and contents as a fully
loaded unit can weigh as much as 800 pounds.
Reinforce the floor as necessary to provide for maximum loading.
For the most efficient refrigeration, be sure to provide good air circulation inside and out.
Inside cabinet:
Do not pack the units so full that air cannot circulate. The refrigerated air is discharged at the top rear of the unit. It is
important to allow for proper air flow from the top rear to the bottom of the unit. Obstructions to this air flow can cause
evaporator coil freeze ups and loss of temperature or overflow of water from the evaporator drain pan. The shelves have a
rear turn up on them to prevent this. However, bags and other items can still be located to the far rear of the cabinet. Air is
brought into the evaporator coil with fans mounted to the front of the coil.
Outside cabinet:
Be sure that the unit has access to ample air. Avoid hot corners and locations near stoves and ovens.
It is recommended that the unit be installed no closer than 2" (51mm) from any wall, and a max door swing clearance of
60.5 in (1537mm).
WARNING
Excessive Weight Hazard
Use two or more persons to move and install appliances.
Failure to do so may result in back or other injury.
Loading ...
Loading ...
Loading ...