Loading ...
Loading ...
Loading ...
3556-VOLT LITHIUM-ION CORDLESS LAWN MOWER — LM2100SP & LM2100
Problem Cause Solution
The mower does not
mulch properly
◾◾
Wet grass clippings are sticking to the
underside of the deck.
◾◾
The mower is set to cut too much grass
at once.
◾◾
Wait until the grass dries before
mowing.
◾◾
Raise the deck to a higher cutting
height setting.
There is excessive
vibration
◾◾
The cutting blade is loose.
◾◾
The cutting blade is unbalanced.
◾◾
The cutting blade is bent.
◾◾
The motor shaft is bent.
◾◾
Tighten the blade bolt.
◾◾
Balance the blade following the
instructions.
◾◾
Replace the blade.
◾◾
Contact the service center.
The handle-locking
clamps cannot be closed
in position
◾◾
The side rails are not fully extended.
◾◾
Fully extend the side rails, then lock
the clamps.
Mower is difcult to
pull back when the self
propel is turned off.
◾◾
The wheels are temporarily locked.
◾◾
Simply push ahead slightly and then
move the mower as desired.
The motor works but the
blade doesn’t cut the
grass.
◾◾
The blade is not tightened to the required
torque.
◾◾
Re-tighten the blade. The
recommended torque for the blade bolt
is 36-43 ft-lb (49-59Nm)
Short running time of
the mower with included
battery
◾◾
Grass conditions and cutting height
setting will greatly affect the battery run
time. The claimed run time is based on a
light load condition.
◾◾
Raise the blade height and slow your
pace to reduce the cutting load
Loading ...
Loading ...
Loading ...