Loading ...
Loading ...
Loading ...
9
INSTALLATION INSTRUCTIONS
BEFORE USING YOUR MERCHANDISER
• Remove the exterior and interior packaging.
• Before connecting the merchandiser to the power source, let it stand upright for approximately 4
hours. This will reduce the possibility of a malfunction in the cooling system from improper handling
during transportation.
• Clean the interior surface with lukewarm water, using a soft cloth. (Refer to Cleaning Your
Merchandiser on page 11.)
INSTALLING YOUR MERCHANDISER
• This appliance is designed to be free standing only, and should not be recessed or built-in.
• Place your merchandiser on a floor that is strong enough to support the merchandiser when it is fully
loaded.
• Allow 5 inches (127 mm) of space between the back and sides of the merchandiser, which allows the
proper air ventilation. Adjust the feet to keep the merchandiser level.
• Locate the merchandiser away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption.
Ambient temperature below 60°F or above 77°F will hinder the performance of this appliance. This
unit is not designed for use in a garage or any other outside installation.
• Avoid installing the merchandiser in moist areas.
• Plug the merchandiser into dedicated, properly installed-grounded wall outlet. DO NOT under
any circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an authorized
service center. This unit is not designed to be installed in an RV or used with an inverter.
• After plugging the appliance into a wall outlet, turn the unit on and allow the unit to cool down for 2~3
hours before placing food in the merchandiser.
ELECTRICAL CONNECTION
WARNING: Improper use of the grounding plug can result in the risk of electrical shock. If the power
cord is damaged, have it replaced by an authorized service center.
• This merchandiser should be properly grounded for your safety. The power cord of this merchandiser
is equipped with a three-prong plug which mates with standard three prong wall outlets to minimize
the possibility of electrical shock.
• DO NOT, under any circumstance, cut or remove the third ground prong from the power cord
supplied.
• This merchandiser requires a standard 115V~ / 60Hz electrical outlet with three-prong ground.
• This merchandiser is not designed to be used with an inverter.
• The cord should be secured behind the merchandiser and not left exposed or dangling to prevent
accidental injury.
• NEVER unplug the merchandiser by pulling the power cord. ALWAYS grip the plug firmly and pull
straight out from the receptacle.
Loading ...
Loading ...
Loading ...