Loading ...
Loading ...
Loading ...
EN - 5 -
• Do not cover the body or top of freezer with lace. This affects the performance of your
freezer.
• Fix the accessories in the freezer during transportation to prevent damage to acces-
sories.
Installing and operating your freezer
Before starting to use your freezer, you should pay attention to the following points:
• Operating voltage for your freezer is 220-240 V at 50Hz.
• The plug must be accessible after installation.
• There can be an odour when you first switch on the appliance. It will disappear after
the appliance starts to cool.
• Before making the connection to the power supply, ensure that the voltage on the
nameplate corresponds to the voltage of electrical system in your home.
• Insert the plug into a socket with an efficient ground connection. If the socket has no
ground contact or the plug does not match, we suggest you call an authorized
electrician for assistance.
• The appliance must be connected with a properly installed fused socket. Power
supply (AC) and voltage at the operating point must match with the details on the
name plate of the appliance (name plate is located on the inside left of the appliance).
• We do not take responsibility for damages that occur due to ungrounded usage.
• Place your freezer in a place where it won't be exposed to direct sunlight.
• Your freezer should never be used outdoors or left under the rain.
• Your appliance should be at least 50 cm away from stoves, Gas ovens and heater
cores, and should be at least 5 cm away from electrical ovens.
• When your freezer is placed next to a deep freezer, there should be at
least 2 cm between them to prevent humidity on the outer surface.
• Do not place heavy items on the appliance.
• Clean the appliance thoroughly, especially in the interior, before use
(See Cleaning and Maintenance).
• Installation procedure into the kitchen unit is given in the installation
manual. This product is intended to be used in proper kitchen units only.
• The adjustable front legs should be adjusted to make sure your appliance is level
and stable. You can adjust the legs by turning them clockwise (or in the opposite
direction). This should be done before placing food in the fridge.
• Before using your freezer, wipe all parts back with warm water added with a tea
spoonful of sodium bicarbonate, and then rinse with clean water and dry. Replace all
parts after cleaning.
• Install the plastic distance guide (the part with black vanes at the
rear) by turning it 90° as shown in the figure to prevent the condenser
from touching the wall.
• The freezer should be placed against a wall with a free distance not
exceeding 75 mm.
Loading ...
Loading ...
Loading ...