Loading ...
Loading ...
Loading ...
18 49-5000712 Rev. 3
Installation Instructions
INSTALLATION INSTRUCTIONS
Trim Kit Installation Instructions
ŶInstall the 1” x 1-1/2” x 84” long stuffer seal
between the wall sleeve and the unit. A flat-bladed
screwdriver or putty knife is recommended.
ŶAssemble the trim frame by inserting the top and
bottom pieces into side pieces and snapping into
place.
ŶPull the cord through the trim frame and slide the
trim over the unit until flush with the wall or wall
sleeve.
Assemble Trim
Security Brackets Installation
(It is important to install these brackets to prevent
the chassis from being pushed into the room
from the outside.)
Ŷ0HDVXUHWKHZLGWKRIWKHLQVWDOOHGZDOOVOHHYHDQG
choose the appropriate security bracket (24” or 26”)
designed for that sleeve.
ŶThe brackets must be installed so the flanges are
hooked behind the inside flanges of the wall sleeve.
8VLQJWKHVFUHZVSURYLGHGDWWDFKWKHEUDFNHWVRQ
the sides of the chassis.
For 24” sleeves, pull the unit out slightly, hook the
short flange of the 24” bracket behind the sleeve
inside edge and secure to the unit with the two screws
provided. Repeat on the opposite side. Push the unit
all the way back into the case.
For 26” sleeves, hook the short flange of the 26”
bracket behind the sleeve inside edge and secure to
the unit with the the two screws provided. Repeat on
the opposite side.
Hook inside
sleeve edge
and secure
to unit
Hook inside
sleeve edge
and secure
to unit
Hook inside
sleeve edge
and secure
to unit
Hook inside
sleeve edge
and secure
to unit
Loading ...
Loading ...
Loading ...