Loading ...
Loading ...
Loading ...
Acoustic Instrument Transmitter
6
1.Each AMT microphone has a disconnect. (D.C.T.) Connect the cable from the Q7
Transmitter to the 3pin (Ta3) input connector on the microphone.
2.Adjustable Gooseneck
Adjustable at angle to allow sound to escape from instrument and develop naturally.
3.Mounting Screw
To REINFORCE the transmitter’s stability on the bell of saxophone / horn, rubber
protection avoids damage of the instrument.
4.BATT/PO
Power and battery LED, the blue LED remains lit as long as the transmitter has power;
if the blue LED is flashing, the battery need to be replaced immediately.
5.Mute Button
6.Light touch power switch
Tap to turn on, long press (2 seconds) to turn off.
7.Antenna
1/4 wave-length wire type antenna, MUST be fully connected and extended during
normal operations. Reception will be poor without antennas connected.
8.IR infrared port
Receiver infrared beam to synchronize frequencies, hold the transmitter with its IR
port facing directly towards the receiver’s IR port with a distance between 5-20cm.
9.Battery compartment
Insert a standard AA alkaline battery here, make sure to put the battery in the right
polar directions.
10.Battery cover
Pull back gently on this cover at the ribbing and pry upwards to remove
Loading ...
Loading ...
Loading ...