Loading ...
Loading ...
Loading ...
1. Remove all packaging material. This includes the foam base and all
adhesive
outside.
tape holding the beverage center accessories inside and
2. Inspect and remove any remaining packing, tape or printed
materials before powering on the Beverage Center.
Your Beverage Center has two leveling legs which are located in the front
corners. After properly placing your Beverage Center in its final position,
you can level your beverageand and wine center.
Leveling legs can be adjusted by turning them clockwise to lower your
Beverage Center or by turning them counterclockwise to raise your
Beverage Center. The Beverage Center door will close more easily when
the two front leveling legs are extended slightly.
To ensure that your Beverage Center works at the maximum efficiency
it was designed for, you should install it in a location where there is
proper air circulation and electrical connections.
The following are recommended clearances around the beverage
center:
Sides……………2" (50mm)
Top....................2" (50mm)
Back..................2" (50mm)
Do not over fill your Beverage Center for proper cooling.
Note: If your Beverage Center has been tilted for any reason, wait 24
hours before plugging it in.
Ensure the drip tray in the rear of the unit is in the proper position.
Installing Your Beverage Center
Unpacking Your Beverage Center
Proper Air Circulation
Leveling Your Beverage Center
Drip Tray
4
English
Loading ...
Loading ...
Loading ...