Loading ...
Loading ...
Loading ...
Fisheye Parking Camera User Manual
33
Chapter 9 Serial Port Configuration
9.1 Set RS-485
Set RS-485 parameters if the device has been connected to a vehicle detector or other RS-485
devices.
Before You Start
The corresponding device has been connected via the RS-485 serial port.
Steps
1. Go to Configuration → Device Configuration → System Configuration → Serial Ports.
Figure 9-1 Set RS-485
2. Set Baud Rate, Data Bit, Stop Bit, etc.
Note
The parameters should be same with those of the connected device.
3. Select Working Mode.
Application Mode Trigger
Select it if the vehicle detector has been connected via the RS-485 serial port.
Transparent Transmission
Select it, and the network command can be transmitted to RS-485 control command via the
RS-485 serial port.
GPS
The GPS devices are connected to the RS-485 serial port of the device for receiving location
data.
4. Click Save.
9.2 Set RS-232
Set RS-232 parameters if you need to debug the device via RS-232 serial port, or peripheral devices
Loading ...
Loading ...
Loading ...