Loading ...
Loading ...
2
IMPORTANT SAFETY INSTRUCTIONS
WARNING
FOLLOW THESE BASIC PRECAUTIONS TO REDUCE
THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY
WHEN USING YOUR ICE MAKER.
READ ALL INSTRUCTIONS BEFORE USING THE ICE MAKER.
DANGER: RISK OF CHILD ENTRAPMENT:
CHILD ENTRAPMENT AND SUFFOCATION ARE NOT PROBLEMS OF THE PAST. JUNKED
OR ABANDONED APPLIANCES ARE STILL DANGEROUS.
BEFORE YOU THROW AWAY YOUR ICE MAKER: TAKE OFF THE DOOR.
NEVER ALLOW CHILDREN TO OPERATE, PLAY WITH, OR CRAWL INSIDE THE
APPLIANCE.
NEVER CLEAN ICE MAKER PARTS WITH FLAMMABLE FLUIDS. THE FUMES CAN
CREATE A FIRE HAZARD OR EXPLOSION.
DO NOT STORE OR USE GASOLINE OR ANY OTHER FLAMMABLE VAPORS AND LIQUIDS
IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE. THE FUMES CAN CREATE A FIRE
HAZARD OR EXPLOSION.
INSTALLATION INSTRUCTIONS
BEFORE USING YOUR ICE MAKER
REMOVE THE EXTERIOR AND INTERIOR PACKING.
VERIFY THAT YOU HAVE ALL OF THE FOLLOWING PARTS:
1 ICE BUCKET
1 PLASTIC SCOOP
1 HOSE, 25 FT.
1 INSTRUCTION MANUAL
BEFORE INSTALLING AND USING YOUR NEW ICE MAKER, LET IT STAND UPRIGHT FOR A
MINIMUM OF 4 HOURS. THIS WILL REDUCE THE POSSIBILITY OF A COOLING SYSTEM
MALFUNCTION FROM IMPROPER HANDLING DURING TRANSPORTATION.
CLEAN THE INTERIOR SURFACE WITH LUKEWARM WATER USING A SOFT CLOTH.
INSTALLING YOUR ICE MAKER
THIS APPLIANCE IS DESIGNED TO EXHAUST HOT AIR THROUGH THE FRONT VENT. THIS
ALLOWS FOR INSTALLATION IN A RECESSED OR BUILT-IN APPLICATION, IF DESIRED.
THIS APPLIANCE IS DESIGNED TO BE EITHER FREE-STANDING OR BUILT-IN (FULLY
RECESSED). IF FREE STANDING, THE UNIT SHOULD HAVE AT LEAST 4” OF CLEARANCE
AT BOTH SIDES, AT THE TOP AND AT THE BACK TO ALLOW FOR ADEQUATE VENTILATION.
IF IT IS BUILT-IN, LEAVE AT LEAST 3/16” AT BOTH SIDES, 1/16” AT THE TOP AND 2” AT THE
REAR. BE SURE THAT AIRFLOW UNDER THE APPLIANCE IS NOT BLOCKED.
PLACE YOUR ICE MAKER ON A LEVEL SURFACE THAT IS STRONG ENOUGH TO SUPPORT
THE ICE MAKER WHEN IT IS FULLY LOADED. REMEMBER THAT THE UNIT WILL BE
SIGNIFICANTLY HEAVIER ONCE IT IS OPERATIONAL AND FULLY LOADED. LEVEL YOUR ICE
MAKER BY ADJUSTING THE LEGS AT THE FRONT OF THE ICE MAKER.
LOCATE THE ICE MAKER AWAY FROM DIRECT SUNLIGHT AND OTHER HEAT SOURCES
(STOVE, HEATER, RADIATOR, ETC.). DIRECT SUNLIGHT MAY AFFECT THE FINISH.HEAT
SOURCES MAY INCREASE ELECTRICAL CONSUMPTION. EXTREMELY COLD AMBIENT
TEMPERATURES MAY CAUSE THE ICE MAKER TO MALFUNCTION. THIS ICE MAKER IS
DESIGNED FOR INSTALLATION AND USE INDOORS IN CONTROLLED AMBIENT
CONDITIONS.
AVOID LOCATING THE ICE MAKER IN MOIST/HUMID AREAS. EXCESS MOISTURE IN THE AIR
MAY CAUSE FROST TO FORM QUICKLY ON THE EVAPORATOR AND CABINET, REQUIRING
Loading ...
Loading ...
Loading ...