Loading ...
Loading ...
Loading ...
1110
CLEANING & MAINTENANCE
Changing the Activated Carbon Pre-Filter
1. Release the inlet grill by pressing on the locking latch (see the
product diagram on Page 7).
2. Remove the inlet grill from the unit.
3. Grasp the pre-lter from the backside of the inlet grill and
remove the pre-lter.
4. Insert new pre-lter into the inlet grill.
5. Reattach the inlet grill and secure the locking latch into place.
6. Press and hold the Timer and UV buttons at the same time for 3
seconds to reset the Filter Change Indicator.
Cleaning External Surfaces
1. Turn o and unplug the air purier.
2. Use a washcloth, slightly dampened with water and dishwashing
soap, to wipe the outer case surfaces.
3. DO NOT allow water to slip into the internal parts as this could
damage the product and result in electrical shock and injury.
4. Allow the air purier to thoroughly dry before use.
UV Lamp Maintenance
The UV lamp is designed to provide up to 12 months of continuous,
eective operation. After this time, the bulb may remain illuminated,
but its eectiveness will be reduced. For maximum eectiveness,
please replace the UV bulb annually.
If the lamp stops functioning or needs replacement, visit our
website at pureenrichment.com to order a replacement lamp.
Caution:
• DO NOT touch the glass part of the lamp. Oil from ngertips will
decrease the eectiveness of the lamp.
• Never operate the air purier without a lter or with a damaged
lter. The UV lamp cover must be installed at all times. The UV
light from the UV lamp will result in severe damage to eyes and
could cause blindness.
CLEANING & MAINTENANCE
To keep your air purier functioning properly, we recommend
changing the True HEPA lter and activated carbon pre-lter after
approximately 6 months of usage. More frequent changing will
be necessary if the product is used in an area with a high level of
airborne contaminants (such as excessive amounts of smoke, pet
dander, etc.). Exposing the product to candle/oil/replace and smoke
is not recommended and will require more frequent maintenance.
NOTE: ALWAYS MAKE SURE THE AIR PURIFIER IS TURNED
OFF AND UNPLUGGED BEFORE THE CHANGING FILTER OR
CLEANING.
• DO NOT use water or any household cleaners or detergents
to clean the True HEPA lter.
• The inlet grill may be cleaned (after the unit is turned o and
unplugged) with a vacuum or a slightly damp cloth.
Changing the True HEPA Filter
1. Release the inlet grill by pressing on the locking latch (see the
product diagram on Page 7).
2. Remove the inlet grill from the unit as shown below.
3. Grasp the left and right frames of the True HEPA Filter through
the indentations on the sides of the lter enclosure and remove
the lter.
4. Insert the new True HEPA Filter. Make sure it is facing the
correct direction.
5. Reattach the inlet grill and secure the locking latch into place.
6. Press and hold the Timer and UV buttons at the same time for 3
seconds to reset the Filter Change Indicator.
Loading ...
Loading ...
Loading ...