Loading ...
Loading ...
Loading ...
MPWT60RGB
6.5” (165 mm) 2-Way Marine/Powersports
Roll Cage/Waketower Speaker Pods
STEP6STEP5
Speaker installation now completes.
As illustrated, secure the aluminum bands to the
metal base using a pair of M6 x 60mm screws,
M6 flat washers, and M6 locknuts. The locknuts
must be installed into the hex shaped recess on
one end of each aluminum band.
Hand-tighten the screws to the degree which
allows just enough freedom to rotate the speaker
around the cage bar.
Wiring
Male LED
connector
LED power wire
1
2
3
1
LED wire connection
Using the supplied LED connection wire with female
connector, connect the two speakers through the male
LED connectors.
2
Speaker wire connection
Using speaker wires (not included) , connect the two
speakers to the audio outputs on your 12VDC amplifier.
Make sure to observe polarity
.
3
LED power connection
Connect one end of the supplied LED power wire to the
power input on the speaker, and the other end to the
12VDC source battery (red color to the positive terminal,
black to the negative terminal).
You may also connect the LED power wire to the
vehicle accessory power (red color to the positive
wire of accessory power and black to the negative
wire of accessory power).
Warning:
● For safety, disconnect the negative terminal from
the source battery prior to wiring.
● Note your amplifier impedance stability prior to
wiring.
● Use only high quality marine-grade speaker wires.
Make sure wires are not squeezed or damaged
by sharp edges.
Tip:
Loading ...
Loading ...