Loading ...
Loading ...
Loading ...
ዀ
ȁ
16
Problem Cause Remedy/Action
Motor fails toturn on.
1. Power cord is not plugged
in.
1. Insure power cord is plugged in securely to
a 110-120V source.
2. Circuit breaker on log
splitter control box is
tripped.
2. Press reset button located next to on/off
switch. If unit does not reset wait two minutes
and repeat.
3. Power cord is damaged
or faulty.
3. Have a qualified electrician or service center
replace power cord with Swisher factory cord.
4. Circuit breaker at power
source is thrown.
4. Check circuit breaker, Only use a dedicated
curcuit to avoid overloading breaker.
5. Faulty or disconnected
power switch.
5. Have a qualified electrician or service center
replace power switch with Swisher factory
switch.
6. Faulty electric motor.
6. Have a qualified electrician or service center
replace electric motor with Swisher factory
cord.
GFCI on power cord is
tripped
Reset GFCI.
Cylinder rod will not
extend or contract.
1. Low hydraulic fluid. 1. Fill hydraulic tank to correct fluid level.
2. Hydraulic lines blocked. 2. Flush and clean hydrualic system.
3. Damaged or broken pump.
3. See authorized service center.
4. Damaged control valve. 4. See authorized service center.
Cylinder rod is slow or
erratic while extending
and contracting.
1. Low hydraulic fluid. 1. Fill hydraulic tank to correct fluid level.
2. Contaminated hydraulic
fluid.
2. Drain fluid, flush system, and refill.
3. Excessive pump inlet
vacuum.
3. Make certain pump hoses are clear and
unblocked. Make certain hose in not
collapsing under suction.
4. Damaged pump. 4. See authorized service center.
5. Damaged control valve. 5. See authorized service center.
6. Internal cylinder damage. 6. See authorized service center.
Leaking Cylinder 1. Broken seals. 1. See authorized service center.
TROUBLESHOOTING
Loading ...
Loading ...
Loading ...