Loading ...
Loading ...
Loading ...
PMX848BT Front and Back Panel Front and Back Panel Function
1. Mike/Line/Guitar input jacks of MIC channel: The jacks are used to connect
microphones or other audio devices in support of cannon plugs and 6.35 plugs.
2. +48V phantom switch/LED: When this switch is turned on, the +48V LED
lights and DC +48 V phantom power is supplied to the XLR plug on MIC input
jack.
NOTICE
Be sure to leave this switch o if you do not need phantom power. Follow the
important precautions below, in order to prevent noise and possible damage to
external devices as well as the mixer if you turn this switch on. Be sure to leave
this switch o when you connect a device that does not support phantom power
to channel. Make sure to turn this switch o when connecting/disconnecting a
cable to/from channel. Slide the knob on channel to minimum before turning
this switch ON/OFF.
3. Guitar/Line input shifter: The switch is used to shift the connections to
dierent sound sources of the input channels. Switched up, the input channel
can be connected directly with a high impedance audio device such an electric
guitar or a bass. Switched down, it can be connected to a low-impedance
sound device.
Warning!
In operation of the switch, all level output control (such as channel volume knobs,
monitor output knobs and earphone knobs) should be set up to the minimum
position. Because this operation will cause a sudden impact sound, which can
damage the external devices, and the hearing of the personnel on site.
4. Mic input CH 2 band EQ: This is a high quality, sensitive, 2 segment equalizer
that adjusts the overall tone of the channel. The adjustment wave form of the
high and low bass equalizer is the shape of the broom, which aects the
frequency of 12KHz and the sound below 80Hz;
5. FX send knob: Adjust the size of the signal sent to the digital eect processor.
The signal transmitting point is located after the volume knob of the channel;
6. PAN knob: Positions the channel signal between L/R in the stereo mix;
7. MIC input volume knob/peak LED: Adjust the volume of the sound input
from the microphone or other source connected to channel. When the peak
light ashes, indicating that the input signal is too high, please turn the
volume knob to the left to reduce the volume. In normal use, please avoid the
peak light for a long time;
www.PyleUSA.com
6
www.PyleUSA.com
7
Loading ...
Loading ...
Loading ...