Loading ...
Loading ...
Loading ...
Page 7
WARNING:
Never use blades, wire, or rope on this product. Do not
use any attachments or accessories not recommended
by the manufacturer of this product. The use of attach-
ments or accessories not recommended can result in
serious personal injury.
ASSEMBLING THE TOOL
See Figure 2.
WARNING:
Never install, remove, or adjust the lower end of the tool
while the unit is running. Make sure the switch trigger is
locked out in the off position. Failure to stop the motor
can result in serious personal injury.
Make sure the switch trigger is locked out in the off posi-
tion.
Align the ridge on the upper end of the tool with the groove
on the lower end of the tool.
Insert the lower end of the tool into the opening on the
upper end of the tool. When the lower end of the tool is
fully seated, the button will snap into place.
CAUTION:
Be careful when sliding the two ends together to avoid
pinching your hands or fingers.
NOTE: Once assembled correctly, the upper and lower end
of the tool should not separate when pulled. Repeat above
steps if pieces can be separated.
WARNING:
Failure to properly assemble the tool as described above
could result in the tool separating and cause serious
personal injury.
ATTACHING GRASS DEFLECTOR
See Figure 3 - 4.
WARNING:
The line cut-off blade on the grass deflector is sharp.
Avoid contact with the blade. Failure to avoid contact
can result in serious personal injury.
NOTICE:
Failure to attach the grass deflector prevents the line
being cut to the proper length and can cause tool failure.
Make sure the switch trigger is locked out in the off posi-
tion.
Remove the screw from the trimmer head and keep aside.
Fit the grass deflector into the slots on trimmer head,
attaching the front slot first as shown.
Hold the back of the deflector in place and line up the
screw hole in the grass deflector with the hole in the
trimmer head.
Reinstall the screw and tighten by turning clockwise with
a Phillips screwdriver.
WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
ASSEMBLY
OPERATION
Loading ...
Loading ...
Loading ...