Loading ...
Loading ...
Loading ...
4
Total Control
TKP-7600
Owner’s Manual
Installation
The TKP-7600 is wall mountable and ts into a standard dual gang (J-box or
Mud Ring) opening. Prior to installation, make sure power is available at the
preferred location.
Power can be supplied to the TKP-7600 through an Ethernet (RJ45) cable connected
to a PoE (Power over Ethernet) in either of the following ways:
• Router/Switch
• PoE Injector
Power over Ethernet describes a system that passes electrical power safely, along
with data, along Ethernet cabling. A shielded Ethernet cable is preferred. The IEEE
standard for PoE requires a Category 5 or higher for high power levels.
Using the Spacers
Use the spacers when installing the mounting ring on to a gang box. The spacers
are NOT needed when using a p-ring.
Included in the box are four (4) spacers that are to be used at specic
installation sites. Most new homes are retrotted with plaster ring boxes
(p-ring) that allow the TKP-7600 to be mounted at and ushed to the wall
without the user of spacers.
However, in some instances, the only boxes that are in the home are dual-gang
boxes. In those situation spacers are REQUIRED in order to install the TKP-7600.
Use the spacers as a buffer between the mounting ring and the dual-gang box,
this can be done by using a screw to secure the mounting ring to the box.
With this the TKP-7600 can sit ush and at on its mount without the risk of
bending or breaking the dual-gang box.
Mounting Ring
Spacers
Dual-Gang
Loading ...
Loading ...
Loading ...