Loading ...
Loading ...
Loading ...
16
Adjusting the angle of motor housing
Press the angle adjustment button on motor housing, push back and
forth the shaft to adjust the motor housing(7 positions) .
Convert to edging mode
The wheeled edge guide should only be used when in the edging
mode.The trimmer can be used in trimming mode or edging mode to
trim
overhanging grass along lawn edges and flower beds.
For edging, the trimmer head should be in the position shown in figure 13.
If it is not:
To switch from trimming to edging, press the edger function switch on the
tool, and firmly holding the telescopic shaft in one hand and turn the rear
handle to right by the other hand (See fig.14).
OPERATING THE TRIMMER
WARNING: Make sure that the work area is free of rocks, debris, lines and other foreign
objects.
1. Lower the protector to prevent the motor housing from getting too close to an object such as a tree
trunk or wall and causing damage to the trimming spool.
2. Start the trimmer before approaching the grass to be cut.
3. Cut the grass by moving the trimmer from right to left and proceed slowly keep the trimmer inclined
forwards at an angle of about 30ยบ light cuts are better than heavy cuts as they allow the cut grass to fall
away from the motor housing.
4. High grass should be cut in layers always beginning from the top. Do not cut damp or wet grass. Do not
overload your trimmer.
5. Watch out for kickbacks in the event of impact with hard objects.
6. After finishing the cutting operation, keep the head close to ground level, release the switch and allow
the motor to come to complete standstill. Place the trimmer on the ground and remove the battery pack
from the trimmer.
Note: Periodically clean out the grass between the spool and the rim of the guard to prevent the tool from
vibrating.
Fig.12
Fig.14
Fig.13
Loading ...
Loading ...
Loading ...