Smeg U8L080DE Built-in refrigerator

User manual EN - Page 12

For U8L080DE.

PDF File Manual, 15 pages, Read Online | Download pdf file

U8L080DE photo
Loading ...
Loading ...
Loading ...
Problem Possible cause Solution
The compressor operates contin‐
ually.
Temperature is set incorrectly. Refer to "Control panel" chapter.
Many food products were put in
at the same time.
Wait a few hours and then check
the temperature again.
The room temperature is too
high.
Refer to "Installation" chapter.
Food products placed in the ap‐
pliance were too warm.
Allow food products to cool to
room temperature before storing.
The door is not closed correctly. Refer to "Closing the door" sec‐
tion.
Door is misaligned or interferes
with ventilation grill.
The appliance is not levelled. Refer to installation instructions.
Door does not open easily. You attempted to re-open the
door immediately after closing.
Wait a few seconds between
closing and re-opening of the
door.
The lamp does not work. The lamp is defective. Refer to "Replacing the lamp"
section.
There is too much frost and ice. The door is not closed correctly. Refer to "Closing the door" sec‐
tion.
The gasket is deformed or dirty. Refer to "Closing the door" sec‐
tion.
Food products are not wrapped
properly.
Wrap the food products better.
Temperature is set incorrectly. Refer to "Control panel" chapter.
Appliance is fully loaded and is
set to the lowest temperature.
Set a higher temperature. Refer
to "Control panel" chapter.
Temperature set in the appliance
is too low and the ambient tem‐
perature is too high.
Set a higher temperature. Refer
to "Control panel" chapter.
Water flows on the rear plate of
the refrigerator.
During the automatic defrosting
process, frost melts on the rear
plate.
This is correct.
There is too much condensed
water on the rear wall of the re‐
frigerator.
Door was opened too frequently. Open the door only when neces‐
sary.
Door was not closed completely. Make sure the door is closed
completely.
ENGLISH 25
Loading ...
Loading ...
Loading ...