Loading ...
Loading ...
Loading ...
26
en | RE3-RX r eceiver
RE3 UHF
Wireless
20
21.06 | 3 | F.01U.362.808 Installation manual Electro-
Voice
2. Frequency
Submenu selection to access manual control in setting frequency.
Selecting opens frequency submenu.
3. Group/Channel
Submenu selection to access manual control in setting group and
channel. Selecting opens Group/Channel submenu.
4. Squelch
Submenu selection to access squelch setting to control background
radio noise. Selecting opens squelch submenu. Factory default is 0
(zero).
5. Mic Config
Submenu selection to access a variety of microphone transmitter
parameters, which transfer to the transmitter during SYNC operation.
Selecting opens MicConfig submenu.
6. Volume
Submenu selection to access manual control of receiver output
volume. Selecting opens setup volume submenu.
7. RX output level
Submenu selection to access manual control of receiver output level.
Selecting opens output level submenu where MIC level or LINE level
are options.
8. Antenna Power
Submenu selection to access manual control of receiver antenna
booster feed voltage. Selecting opens Antenna Power submenu where
ON and OFF are options. Factory default is ON.
9. Keylock
Submenu selection to access manual control of Keylock feature
operating status. Selecting opens Keylock where ON and OFF are
options. Factory default is OFF.
a. Display option
Submenu selection to access manual control of receiver display
characteristics. Selecting opens Display Options submenu where
contrast and brightness are controlled. Factory defaults are 4.
b. Reset
Submenu selection to access a manual receiver reset to factory
default settings. Selecting opens reset submenu.
c. Exit Returns to home screen.
7.3.3 Scanning for open channels
Three methods are available. 1) Briefly press the SCAN button on the front panel to open
the Scan submenu (arrive at step 1 below). 2) Press and hold SCAN button on the front
panel for 3 seconds to enter “Scan All Groups” dialog (arrive at step 2 below). 3) Select 1
from the main menu to open Scan submenu.
1 Select 1. All Groups and press SET to begin scan process.
Loading ...
Loading ...
Loading ...