Loading ...
Loading ...
Loading ...
DS-3WF03C User Manual
28
Ping IP: User can input the destination IP address of another device, and click Ping button. If that
destination device is successfully connected to the DS-3WF03C device, the result shows Alive,
otherwise shows Not Alive.
Time to Reboot: Timing restart equipment.
NTP: If this NTP server is set, and the DS-3WF03C device can access to this NTP server. DS-3WF03C
device automatically calibrate the time and date information with the NTP server and show the
time information in the Status page.
Ping Watchdog: The ping watchdog sets the DS-3WF03C device to continuously ping a
user-defined IP address (for example, it can be the IP address of the AP the Client is connecting to).
If it is unable to ping under the user defined constraints, the DS-3WF03C device will automatically
reboot. It is highly recommended that users enable this feature at the side of “Station” and disable
this feature at the side of “Access Point”.
Ping Interval: Specify time interval (in seconds) between the ping requests are sent by the Ping
Watchdog.
Ping IP Address: Specify an IP address of the target which will be monitored by Ping Watchdog. If
this feature is enabled at the side of “Station”, Ping IP Address should be the IP address of the AP
the Client is connecting to.
Startup Delay: specify initial time delay (in seconds) until first ping request is sent by the Ping
Watchdog.
Ping Failure: Specify the number of ping replies. If the specified number of ping replies is not
received continuously, the Ping Watchdog will reboot the device.
If users want to modify the parameters of Ping Watchdog, please disable it first and then apply.
When the web page shows that Ping Watchdog is really disabled, users can now re-enable it
with modified parameters.
Syslog: When Syslog is enabled, and the System Log server’s IP is also set here, the log information
will be output to the Syslog server automatically.
SNMP: When SNMP is enabled, use can check the working condition and information of the
DS-3WF03C device.
Spectral Scanning: Spectral scanning function can view around the 20MHz bandwidth frequency of
the use situation; this can help you configure the device to avoid busy frequency. If you run the
spectral scanning, you cannot do any configuration operations on the device page. If you want to
configure the device again, you only need to click the exit button in the spectral scanning web page
to exit.
Antenna Calibration 5G: Outdoor remote adjustment of the antenna angle used, every few
seconds to refresh the current 5G associated signal strength histogram, the user can judge the
current two devices according to the two antenna is at the best angle.
Loading ...
Loading ...
Loading ...