Loading ...
Loading ...
Loading ...
Thermal & Optical Bi-spectrum Network Camera
71
Note
Server Address is NTP server IP address.
5. Click Test to test server connection.
6. Click Save.
12.9.3 Set DST
If the region where the device is located adopts Daylight Saving Time (DST), you can set this
function.
Steps
1. Go to Configuration → System → System Settings → DST.
2. Check Enable DST.
3. Select Start Time, End Time and DST Bias.
4. Click Save.
12.10 Power Consumption Mode
It is used to switch the power consumption when the device is working.
Note
The function is only supported by certain camera models.
Go to Configuration → Proactive Mode → Power Consumption Mode, select the desired power
consumption mode.
Performance Mode
The device works with all the functions enabled.
Proactive Mode
The device DSP works normally. It records the videos with the main stream at the half frame
rate, and supports the remote login, preview and the configuration.
Low Power Sleep
When the device power is lower than Threshold of Low Power Sleep Mode, the device enters
sleep mode.
When the device power is recovered to 10% above the threshold, the device enters the user
configuration mode.
Scheduled Sleep
If the device is during Scheduled Sleep Time, it enters the sleep mode, otherwise it enters the
user configuration mode.
Loading ...
Loading ...
Loading ...