Loading ...
Loading ...
Loading ...
- 34 - - 35 -
8. Lift and position the hood onto the brackets at
the top of the backside while keeping an angle
between the wall and the hood, and then push
the hood against the wall tightly. Secure the
duct to the duct cover and seal the connection
with aluminum tape.
Caution: Two installers are required to ensure
safe installation.
9. Install the decorative plate.
Use four 3.5 x 35 wood screws to fix the
decorative plate on to the upper cabinet.
10. Make sure the hood is leveled. Install the
Grease Cup, and plug the appliance for a test run.
Installation Instructions for the Decorative
Cover Without Upper Cabinet
Diameter of smoke
tube Φ6" (152.5mm)
Diameter of hole digging
Φ6 1/2" (165mm)
1. Unpack the appliance and check the List of
Accessories.
2. Locate the wooden beam and mark the
location with a pencil. Mark another beam 16"
or 24" to either side of this mark.
Framing Stud
3. Locate the duct bracket, safety buffer bafe
and decorative cover bracket:
safety stop
mounting hole
2
5
/1
6
"(
5
8
.5
m
m
)
4
9
/1
6
"(
11
5
.5
m
m
)
Max 29 15/16"(760mm)
Max 30 7/8"(783mm)
Min 27 7/8"(708mm)
4
9/16"(115.5mm)
Hole A
Area C
Hole B
Hole A
Area C
Hole B
Caution: one of the brackets for main engine
must be fastened to the beam.Screws must
be fixed at hole A and B in the drawing; also
screws must be fixed at bracket bores with
corresponding wooden stakes in area C.
Firstly determine the installation central point of
the range hood according to the central point
of the cooker, determine the bracket installation
location based on cooker table and mark the
place for drilling. The cooker table is about 27
7/8" (708 mm) to 30 7/8" (783 mm) away from
the central point of bracket;
The location to install the safety buffer baffle
should be 4 9/16" (115.5 mm) to the left of the
duct bracket and 2 5/16" (58.5 mm) straight up.
The location to install the decorative cover
bracket should generally be 29 15/16 " (760
mm) above the central point of the duct bracket.
If the distance between the ceiling and duct
bracket equals to or is less than the value,
secure the decorative cover bracket on the wall
right under the ceiling. If the distance is more
than the value, taller decorative covers (27
9/16" (700 mm) and 35 7/16" (900 mm) in height
respectively) need to be bought separately.
Drill Ø8 hole at the screw hole marks with
electric drill and embed expansion tubes.
4. Secure the duct bracket and decorative cover
bracket to the wall with corresponding screws
and tighten the screws. Make sure the bracket
is leveled.
Caution: One of the screws for duct bracket
must be fastened to the wooden beam.
5. Fasten the gasket seal and duct cover to
the range hood outlet with four M4 x 18 screws
and set four cover screws at the corresponding
places. Fix two bases at corresponding
positions on the back of the range hood with
base screws.
Loading ...
Loading ...
Loading ...