Loading ...
Loading ...
Loading ...
10
COMMISSIONING
BURNER AERATION
All burners have fixed aeration and no adjustment is
possible.
PRESSURE SETTING
Pressure test point: Use the oven injector.
HOB BURNER
Turn the control knob to the ‘FULL ON’ position, wait a
second before pressing the ignition switch or holding
a lighted match or taper to the burner. Hold the
control knob in for 15 seconds. Do not hold the control
knob in for longer than 15 seconds. If the burner fails
to light within this time, release the control knob and
wait one minute before attempting further ignition.
CHECK THE OPERATION OF
ELECTRICAL COMPONENTS
Clock Programmer/Minute Minder
Check functions as described in the User Guide.
Oven light & Convection fan
Open the main oven door. Turn the main oven control
knob to the defrost setting. Check the oven light and
convection fan both come on. Turn control knob back
to ‘OFF’ position.
Cooling Fan
Open the grill door. Turn the grill control knob to the
full power setting.
Check that the cooling fan operates. Turn control knob
back to ‘OFF’ position and check cooling fan switches
off immediately.
Lid Safety system (if fitted)
Ignite all hotplate burners including wok. Attempt to
close the lid and make sure all flames are extinguished
by the safety system.
If you are satisfied that the cooker is operating
correctly, turn it off and show the customer how to
use it. Make sure you ask the customer to operate the
clock (if fitted) and controls.
Explain to the user that the lid safety system must
not be used as a means of turning off the hotplate
burners. Control knobs must always be turned to the
‘OFF’ position after use.
4
Note: If the cooker does not perform
correctly, inform the customer of the
problem and put a warning notice on the
cooker. If the problem is dangerous, then
disconnect the cooker. If there is a fault,
then the customer should be advised to
contact the manufacturer’s local service
organisation or the retailer.
4
Before leaving the installation hand
over the User Guide to the customer
Loading ...
Loading ...