Loading ...
Loading ...
Loading ...
15
English
IV-2. Gooseneck Mounting: AM-221
Below is a sample procedure using a gooseneck bracket:
1. Determine a hard surface wall location. Use the alignment sticker to mark the positions
where holes will be drilled for the gooseneck bracket.
1
2
3
5
HD WDR Pro
4
2. Drill 4 pilot holes (10mm in diameter and 5.5cm deep) into the wall, and then hammer in
threaded anchors. Note that you should hammer the anchors with hex nuts on them so
that the threaded poles will not be deformed! If preferred, drill another hole for routing
cables.
3. Secure the wall mount bracket to wall using 4 sets of lock washers and nuts.
4. Attach the top section (dome cap and interface section) of the camera to the gooseneck
bracket
5. Align the camera body with the top section. Align the
alignment mark on the camera with that on the interface
section. Push the camera up to match the top section.
Install AM-519 adaptor
to the gooseneck.
Alignment mark
Loading ...
Loading ...
Loading ...