Loading ...
Loading ...
Loading ...
EN 16 17 EN
Place the brush roller vertically as shown in the illustration and leave it
for at least 24 hours to dry thoroughly. Before installing it back, make
sure the brush roller is completely dry.
Slide the brush roller back to the brush head and reinstall the end cap
on the main brush roller.
The end cap should be in a position where the figure shows. After it is
installed, gently press and rotate the end cap to the closed position.
Make sure the fasteners are rotated into place and the brush roller is
fixed.
Remove the brush roller as described above, clean the foreign matter
such as the wrapped hair, and then install the brush roller back.
Do not accidentally touch the switch during the removal of the brush
roller and the installation of the brush roller to avoid injury.
If the battery temperature is below 0 °C, the machine will be turned off
to protect the motor and battery. Do not charge the product and store it
at a temperature below 0 °C.
To extend battery life, please avoid charging immediately after full
discharge, the product needs to be cooled for a few minutes.
Avoid using the product when the battery surface is hot. Running the
machine at a low temperature helps to extend the working time and
service life of the battery.
If you do not use the vacuum cleaner for a long time, remove the battery
from the battery compartment and place it in a cool place.
Brush Head Maintenance
—— Clear Obstacles
Empty the Dust Container
Low suction or almost no suction
The product is hot while using
The product in normal mode can work up to 40 minutes, and in
the boost mode is up to 22 minutes. After the product is used for
a period of time, the suction will decrease with time. If the suction
becomes smaller, first think about the product usage time.
If the suction is small at initial, please check whether the product is
fully charged.
Check if the filter is dirty.
If the above reason is excluded, please contact us.
[support@holife.com]
Please power off first, and check if the dust container is full. if the
dust container is full, clean it according to the guidelines of emptying
the dust container.
Check if the filter screen and the foam filter element are blocked.
If they are blocked, please clean the filter according to the filter
cleaning operation guide.
Please fully charge the vacuum cleaner before first use.
Before using the vacuum cleaner, check whether the suction head
and accessories are clean.
Before cleaning the floor and carpet, please confirm the manu-
facturer's cleaning guidelines to avoid damage to your carpet and
floor.
The brush roller may damage some carpets or floors. When using this
product for cleaning, the hard brush roller may cause some carpets
to fluff. If it happens, please do not use the electric floor suction head
when vacuuming.
The suction head of the product is not suitable for cleaning carpets
with over 4mm fluff.
Troubleshooting
Usage Instructions
Loading ...
Loading ...
Loading ...