Loading ...
Loading ...
Loading ...
cleaning cont.
If necessary, remove the top cover and disassemble the evaporator cover, water curtain, ice guide and nozzle frame.
Place all components into a basin to soak with approximately 3 quarts of the detergent water mixture for 5 to 20 minutes
depending on how much lime scale build up is present..
Disassemble the spray bar by removing the left and right silicon plugs, and sepate the nozzles and inserts while soaking.
While parts are soaking, Clean the inside of the ice tank with a soft brush and rinse every corner of the inside door,
reservoirs, evaporator frame and evaporator upper pipe part with clean water.
Clean the parts which have been soaking with a soft nylon brush. You may have to use a toothpick to clear the nozzles.
After cleaning, rinse all the parts with clean water.
Re-assemble the unit with the newly cleaned parts.
Pour the remain quart of detergent mixture into the water tank.
Make sure the switch is in the “OFF” position and restore power by plugging the unit in or turning on the breaker.
AUTOMATIC CLEANING:
Start the automatic cleaning process by turning the switch to the “WASH” position.
The automatic cleaning cycle takes 21 minutes to complete. After it is finished set the switch in the “OFF” position.
RINSING:
If any cleaning solution remains in the water tank, remove the drain plug to empty the tank.
Re-install the drain plug, pour one quart of clean water into the water tank and run “WASH” again for 10 minutes.
If any bubbles or residue remains, repeat the rinse operation.
27
Loading ...
Loading ...
Loading ...