Loading ...
Loading ...
Loading ...
32
saturation indicators must be performed within this time
interval.
Reset filter saturation indicators:
Press and hold button
Activation of saturation indicator for activated
charcoal filter
Note: this operation is to be performed with the hood off.
This indicator is normally disabled; press and hold button
to activate the function; the button turns on with
steady light.
To deactivate the function, press and hold button
:
the button turns on with flashing light.
Automatic operation (sensor), connection with SNAP
®
Attention! Proper functioning of the hood depends on the
‘Setting of Parameters for Automatic mode’ (see relevant
paragraph)
Automatic operation (sensor)
Press button
(the button turns on in white).
The hood turns on at the most appropriate speed according to
the cooking fumes detected by the sensor on the hood.
Automatic operation of the hood with SNAP
®
Press button
(the button turns on in orange to indicate
that the hood can operate automatically with SNAP
®
).
Note: SNAP
®
is a unit of auxiliary suction capable of
operating together with the hood. For more information,
consult the manual supplied with the SNAP®
Setting of parameters for Automatic Operation
Note: All calibration, selection, control and logical
connection operations described below are possible with
the hood off (OFF).
Parameter setting is regularly done automatically
whenever the hood is reconnected to the power grid (eg:
first installation or after a blackout) or manually
Manual setting
To perform when you notice an unsatisfactory functioning
of automatic operation and should be performed when in
the kitchen there are normal environmental conditions.
The manual adjustment includes:
• Calibration of the hood:
• Selection of the hob (gas – induction or electric).
• Logical connection between the hood and SNAP
®
(if in possession of SNAP
®
).
Calibration of the hood
Press and hold button
, the button flashes to
indicate that calibration began, the calibration
process will last about 5 minutes.
Selection of the hob (gas – induction or electric)
Press and hold simultaneously buttons
and
: buttons , and start
flashing for 5 seconds.
Within this time interval, press:
button
in case of gas hob
button
in case of electric hob
button
in case of induction hob
The selected button remains on to indicate the
selected was made, after 10 seconds the button will
flash briefly to indicate that the selection you made
was registered.
Logical connection between the hood and SNAP
®
(if
in possession of SNAP
®
).
The connection between the hood and SNAP
®
is automatic.
No setting is required.
Loading ...
Loading ...
Loading ...