Loading ...
Loading ...
Loading ...
4 Operation
4.1 Main switch
WARNING: Read the safety
instructions carefully before you start the
product.
WARNING: Keep your hands and feet
away from the rotating blades. Do not put
your hands or feet near to or below the
product when the cutting motor is on.
WARNING: Do not use the product
when persons, especially children, or
animals are in the work area.
• Set the Main switch in the
1
position to start the
product.
• Set the Main switch in the
0
position when the
product is not in use or before you do inspection or
maintenance on the product.
4.2 To start the product
1. Push the STOP button to open the hatch on the
product.
2. Set the Main switch to position
1
.
3. Enter the PIN code.
4. Push the START button.
5. Select an operating mode. Refer to
Operating
modes - Start on page 32
.
6. Push the
OK button.
7. Close the hatch on the product.
Note: If the product is parked in the charging station,
the product will start to operate when the battery is fully
charged and if the
Schedule
settings is set for operation.
Note: The first weeks after installation the perceived
sound level when cutting the grass may be higher than
expected. When the product has cut the grass for some
time, the perceived sound level is much lower.
4.2.1 Operating modes - Start
•
Main area
•
Secondary area
•
Override schedule
•
Spot cutting
4.2.1.1 Main area
Use the operating mode
Main area
for the product to cut
and charge automatically.
4.2.1.2 Secondary area
Use
Secondary area
operating mode to cut secondary
areas. You must move the product manually between
the main area and the secondary area. The product cuts
for a selected period of time or until the battery is empty.
Note: You must put the product manually in the
charging station to charge the product when it is in a
secondary area. The product will move out from the
charging station and stop when the battery is charged.
You must select an operating mode to start the product.
Note: If you will cut the main area after the battery is
charged, set the product to
Main area
mode before you
put the product in the charging station.
4.2.1.3 Override schedule
Use the operating mode
Override schedule
to
temporarily override the
Schedule
settings for
24h
or
3
days
.
Note:
It is not possible to cut more than the maximum
cutting time for each day. Refer to
Make an estimate of
the necessary operating time on page 23
.
4.2.1.4 Spot cutting
Use the operating mode
Spot cutting
to cut a selected
area in a spiral pattern. You must move the product
32
- Operation 1440 - 004 - 24.03.2021
Loading ...
Loading ...
Loading ...