Loading ...
Loading ...
Loading ...
Page 20
NOTE: The starting position of the choke will vary depending on the engine temperature.
If starting a cold engine, move the lever towards the CHOKE position. If starting a warm
engine, move the lever towards the RUN position.
4. Pull the recoil slowly until resistance is felt, then pull rapidly to start the engine.
The water source should be connected, turned on, any air purged from the system,
and the trigger lock placed in the locked position.
STARTING THE ENGINE
WARNING:WARNING:
Attempting to start the engine incorrectly or using the pressure washer incorrectly can
result in engine and/or pressure washer damage, and may cause serious injury or death.
To avoid these hazards, be sure to read, understand, and follow the steps outlined in the
OPERATING CHECKLIST section of the owner’s manual before starting the engine, and
follow all the guidelines for proper use of the pressure washer.
OPERATING CHECKLIST
NOTICE
Running the pressure washer for more than two minutes without the spray gun trigger
pulled will overheat the pump and possibly cause damage. The thermal relief valve will
open and spray water to help cool the pump as it overheats. To avoid overheating the
pump, shut o the machine if not being used for longer than two minutes.
PUMP DAMAGE
Starting the Engine
1. Complete the steps in the OPERATING CHECKLIST section of this manual before
starting the engine. Failure to do so could cause damage to the pump or engine. If
needed, refer to your Engine Owner’s Manual for specic starting instructions.
2. Rotate the fuel valve to
the ON position.
3.
Slide the control lever
left to the CHOKE position.
Loading ...
Loading ...
Loading ...