Loading ...
Loading ...
Loading ...
12
REMOTE SWITCH INSTALLATION
NOTE: Installation and service must be performed by a qualified
installer/electrician
WARNING:
To avoid fire or electrical shock, turn off the power at the circuit breaker. Test to
ensure that the power is off before starting the wiring.
NOTE: If installing this switch in accordance with ADA guidelines, the height of the
light switch must be no lower than 15” from the floor and no higher than 48” from
the floor. Additional regulations apply if there are any obstructions in front of the
switch. For more information, refer to Section 308 of the most recent ADA
Standards for Accessible Design at ada.gov.
INSTALLING THE MAIN POWER SUPPLY
Attach the power cable located at the back of the unit.
Remove the grease filter.
WIRING
CONNECTING UNIT TO REMOTE SWITCH
Remove the screws attaching the front panel to the unit. Unscrew the control
panel, disconnect it from the junction box, install the provided cable, and run it
along the wall from the hood to where the remote switch will be installed. At the
desired location, install the control panel into the wall.
Use the provided metal hole fillers where the control panel would normally be
on the range hood.
Using your range hood
Loading ...
Loading ...
Loading ...