Loading ...
Loading ...
Loading ...
USER
MAINTENANCE
Your curling iron is virtually maintenance free.
No lubrication is needed. Keep all vents and
openings clear of dirt and dust. If cleaning
becomes necessary, disconnect the unit from
the power source, allow to cool and wipe
exterior with a cloth. If any abnormal condition
occurs, unplug the unit, allow it to cool, and
return it for repair to an authorized service
representative only. No repairs should be
attempted by the consumer.
CAUTION
NEVER allow the power supply cord to be pulled
or twisted. Never wrap the cord around the ap-
pliance. Damage will occur at the high-fl ex point
of entry into the appliance, causing it to rupture
and short circuit.
Inspect the cord frequently for damage. STOP
USE IMMEDIATELY if damage is visible or if unit
stops or operates intermittently.
STORAGE — Important
When not in use, your appliance should be
disconnected and stored in a safe, dry
location, out of reach of children. Do not wrap
line cord around the appliance. Allow the cord
to hang or lie loose and straight at the point of
entry into the appliance.
FEDERAL COMMUNICATIONS
COMMISSION NOTICE
WARNING: Changes or modifications to this
unit not expressly approved by the party
responsible for compliance could void the
user’s authority to operate the equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) This device may not cause
harmful interference, and (2) This device must
accept any interference received, including
interference that may cause undesired
operation.
NOTE: This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
Loading ...
Loading ...
Loading ...