Loading ...
Loading ...
Loading ...
22
PROBLEM POSSIBLE CAUSE/FIXES
Spots and filming
on dishes
Water hardness is too high.
For extremely hard water, install a water softener.
Dishes are loaded improperly.
Reload the dishwasher as shown in “Preparing and loading dishes” on page 9
Old or damp rinse aid power is used.
Use fresh, liquid rinse aid.
The rinse aid dispenser is empty or the setting is too low.
Fill the rinse aid dispenser. Increase the rinse aid setting.
Etching Using too much detergent.
Use less detergent if you have soft water.
The inlet water temperature exceeds 150° F (65.6° C.
Lower the inlet water temperature
Detergent left in
dispenser cup
Detergent may be too old.
Use fresh detergent.
The spray arm is blocked.
When you load the dishes, make sure that the spray arms are not blocked.
The detergent
dispenser will not
close
Improper operation of the detergent cover.
Add detergent and rinse aid only as indicated in this manual. See “Filling the
detergent dispenser” and “Filling the rinse aid dispenser” on page 13-14.
Water remains in
the dishwasher.
The previous cycle has not finished or has been interrupted.
Make sure that the water pressure is above 20 psi. Use your dishwasher when
water demand is low.
The dishwasher
does not drain
properly
The drain is clogged.
Check the air gap (if so equipped). Make sure that the disposer is empty
(if so connected).
The drain hose is kinked.
Make sure that the drain hose is not kinked and is properly connected.
The cycle you chose did not include drying.
Choose a cycle with drying.
Suds in the tub Using improper detergent.
Make sure to use only automatic dishwasher detergent
The dishwasher
leaks
Excessive suds caused by using improper detergent.
Make sure to use only automatic dishwasher detergent.
The dishwasher is not level.
Level the dishwasher (refer to the Installation Manual).
There are black or
gray marks on the
dishes
Aluminum utensils have rubbed against the dishes.
Make sure that the water inlet temperature is not less than 120° F (49° C).
The interior of the
tub is stained
Coee or tea stains. Use a spot cleaner to remove the stains.
Reddish stain. Some tomato products may cause this. Use of the rinse only
cycle right after loading will help this.
Noises Detergent cup opening/drain pump. This is normal.
A hard object has entered the wash module. When the object is ground up
the noise will stop. If the noise continues after the cycle is complete, call for
service.
TROUBLESHOOTING
Loading ...
Loading ...
Loading ...