Loading ...
Loading ...
Loading ...
3. Insert the unit into the cabinet opening. Slide unit 4.
inward leaving 1 3/s" (3.5 cm) clearance between the
oven decorative trim and cabinet. Pull the armored
cable through the hole in the floor and toward the
junction box while moving the appliance inward. Use
the second set of holes in the side frame of the unit as
a guide to find the position of the mounting brackets
on the sides of the cabinet opening. Mark the position
of the mounting brackets as shown in Figure 8 or 9.
Pull out the oven approximately 1 foot (30.5 cm)
away from the cabinet. Reposition each bracket on
the cabinet and drill 1/8" pilot holes. Fasten the
brackets in place using the 2 screws supplied (#10 x
1 1/4" long).
If needed, add wood spacers at the mounting
bracket locations to reduce the cabinet opening to
28 1/2" (72.4 cm).
Now push the unit in and against the cabinet, then
attach the unit to the mounting brackets using the
2 screws removed earlier from the side frame.
Side filler panels are necessary to isolate
the unit from adjoining cabinets.
To reduce the risk of
personal injury and
tipping the wall
oven, the wall oven
must be secured to
the cabinet(s) by
properly installed
mounting screws or
brackets,
4 1/2"
(1 1.4 cm)
Max.
36" Min.
(91.4 cm)
Use3/4" (1.9 cm) plywood, installed
on two runners, flush with toe plate.
Must be capable of supporting 150
pounds. (68 kg).
Cut an opening in wood base
minimum 9" x 9" (23 x 23 cm), 2"
(5 cm) from left side filler panel, to
route armored cable to the wall
outlet or junction box.
30" (76.2 cm) 28 1/2" (72.4 cm) Min. 28 1/4" (71.8 cm) Min.
Wall Oven 29" (73.7 cm) Max. 24" (61 cm) Min. 28 7/8" (73.3 cm) Max.
Figure 10 - TYPICAL UNDER COUNTER INSTALLATION OF AN ELECTRIC BUILT-IN OVEN
30" SINGLE WALL OVEN ONLY
Loading ...
Loading ...
Loading ...