Loading ...
Loading ...
Loading ...
accessories running over rated speed can fly apart and cause injury.
Accessory ratings must always be above tool speed as shown on
tool nameplate.
ATTACHMENTS
Attachments designed specifically for this grinder can be
purchased through D
EWALT dealers and DEWALT Factory Service
centers.
9" Type 27 guard D284939
9" Type 28 guard D284938
7" Type 27 guard D284937
6" Type 11 Flaring cup guard with flange D284936
4" Type 11 Flaring cup guard with flange D284934
Type 11 Flaring cup wheel backing flange 608368-00
Type 1 Flange set D284932
7" Type 1 Guard D284931
Grinding backing flange 54339-00
Clamp nut 22191-00
Wheel Wrench 61820-01
Soft mount spindle protector 445928-01
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of injury, turn unit off
and disconnect it from power source before installing and
removing accessories, before adjusting or when making
repairs. An accidental start-up can cause injury.
Attaching the Side Handle (Fig. 3)
Attach the side handle (C) to one of the two
C
H
FIG. 3
side handle ports (H).
Rotating the Gear Case
(Fig. 4)
1. Remove guard and flanges from
FIG. 4
tool.
2. Remove the four corner screws
attaching the gear case to motor
housing.
3. Separate the gear case from
motor housing, not more than
1/4" (6.35 mm), rotate the gear
case head to desired position.
NOTE: If the gear case and motor housing become separated
by more than 1/4" (6.35 mm), the tool must be serviced and
re-assembled by a D
EWALT service center. Failure to have the tool
serviced may cause brush, motor and bearing failure.
4. Re-install screws to attach the gear case to the motor housing.
Tighten screws to 20 in./lbs. torque. Overtightening could cause
screws to strip.
OPERATION
WARNING: To reduce the risk of injury, turn unit off
and disconnect it from power source before installing and
removing accessories, before adjusting or when making
repairs. An accidental start-up can cause injury.
English
9
Loading ...
Loading ...
Loading ...