Broan NRSL130WH NuTone Symmetra 30-inch Under-Cabinet Range Hood, 300 Max Blower CFM

INSTALLATION, USE AND CARE MANUAL - Page 17

For NRSL130WH. Series: NRSL1
Also, The document are for others Broan models: CRDEG1*, CRSA1*, CRSH1*, NRSL1*

PDF File Manual, 60 pages, Read Online | Download pdf file

NRSL130WH photo
Loading ...
Loading ...
Loading ...
INSTALLATION MANUAL
INSTALLATION
17
Install the Hood (EZ1 Bracket)
1 ] Run house power cable between service panel and hood location.
2 ] There are 2 pairs of recessed holes on each side of the top of the hood (on rear: A and B,
on front C and D on illustration below); these holes allow the range hood to hang on the
brackets (previously installed).
3 ] Temporarily hang the hood on the brackets using its (2) recessed REAR HOLES (A and B).
While holding the hood, run the house power cable into the hood through the strain relief
previously installed in step 6 on page 12.
4 ] Unhook the rear holes from the brackets and hang the hood using its (2) recessed FRONT
HOLES (C and D). While holding the hood, attach power cable to the hood using the strain
relief.
5 ] Hang the hood on the brackets using the (2) recessed FRONT HOLES (C and D). While
holding the hood, run power cable to the hood using the strain relief previously installed in
step 6 on page 12. Attach power cable to the hood.
6 ] Connect ductwork to hood and use metal foil duct tape to make joints secure and air-tight.
Make sure the damper assembly (or round duct plate) enters the ductwork and that the
damper opens and closes freely.
NOTE: See final installation steps on next page.
HORIZONTAL EXHAUST INSTALLATION
OTE: N The following procedure applies to both frame or frameless cabinet installations.
A
B
C
D
A
B
DUCTED INSTALLATION ONLY
VERTICAL EXHAUST INSTALLATION AND NON-DUCTED INSTALLATION ONLY
Loading ...
Loading ...
Loading ...