Loading ...
Loading ...
Loading ...
RE3
UHF Wireless RE3-HHT handheld tr ansmitter | en 43
Electro
-Voice Installation manual 2021.06 | 03 | F.01U.362.808
c AutoOff icon
The display shows this icon when auto off is engaged. It begins
flashing when the transmitter is muted indicating the countdown
to shutoff has begun.
d
Mute
The display shows MUTE only when the transmitter is muted.
e Frequency in kHz
The portion of the tuned frequency to the right of the decimal in
thousands when the transmitter home screen is set to Freq.
f
Battery status
icon
Indicates battery life.
= between 40% and 100% charge remains.
= between 20% and 39% charge remains.
= between 10% and 19% charge remains.
= below 10% charge remains.
BATTLo appears on the display and the empty cell icon begins
flashing when batteries are nearing empty.
g
Keylock icon
Indicates transmitter is in lock mode.
8.3 Installing batteries
While gripping the transmitter handle/battery cover section (item 2 shown above)
with one hand, grip the control section (item 3 shown above) with the other hand.
Using a left-hand twist, unscrew the control section until it is free from the handle.
Slide the control section away from the handle until the battery compartment (item 6
shown above) is fully exposed.
Gently rotate the hinged protective battery cover to expose the battery chamber.
Note the battery polarity markings (+ and -) on the protective cover. Both positive
(+) contacts are adjacent to the control section male threads.
Install two fresh, high quality AA alkaline batteries (or fully charged AA size NiMH
rechargeable cells) paying close attention to match the polarity markings (+ and -)
on each battery to the polarity markings (+ and -) of the battery contacts as shown
on the battery cover.
Once both new batteries are properly installed, rotate the hinged protective battery
cover downward until the cover is in contact with the batteries.
Applying the same gripping technique used while opening the transmitter to expose
the batteries, gently slide the battery compartment back inside the handle until the
control section can move no further. Using a right hand twist, screw the control
section onto the handle section until it is tightly threaded on. Be careful not to
overtighten the threads.
8.4 RE3-HHT setup menu
Editing any of the following parameters locally on the transmitter is possible. These edits
will override the settings synchronized from the mated receiver. Additionally, any
parameter value changes made locally on the transmitter may be overwritten the next time
Loading ...
Loading ...
Loading ...