Comfort Aire RADS-51J Owner’s Manual

Loading ...

Heat Controller, Inc. Room Air Conditioner with R-410A Owner’s Manual

IMPORTANTSAFETY INSTRUCTIONS

Besuretheelectricalserviceisadequateforthemodelyouhave

chosen. Thisinformationcanbefoundontheserialplate,which

islocatedonthesideofthecabinetandbehindthegrille.

Besuretheairconditionerisproperlygrounded. Tominimize

shockandfirehazards,propergroundingisimportant. Thepower

cordisequippedwithathree-pronggroundingplugforprotection

againstshockhazards.

Yourairconditionermustbeusedinaproperlygroundedwall

receptacle.Ifthewallreceptacleyouintendtouseisnotadequately

groundedorprotectedbyatimedelayfuseorcircuitbreaker,

haveaqualifiedelectricianinstalltheproperreceptacle.

Ensurethereceptacleisaccessibleaftertheunitinstallation.

Donotrunairconditionerwithoutsideprotectivecoverinplace.

Thiscouldresultinmechanicaldamagewithintheairconditioner.

Donotuseanextensioncordoranadapterplug.

WARNING

Foryoursafety

Donotstoreorusegasolineorotherflammablevaporsandliquidsin

thevicinityofthisoranyotherappliance.

Avoidfirehazardorelectricshock.Donotuseanextensioncordoran

adaptorplug.Donotremoveanyprongfromthepowercord.

WARNING

ElectricalInformation

NOTE Forsomemodels,thepower

supplycordwiththisairconditioner

containsacurrentdetectiondevice

designedtoreducetheriskoffire.

PleaserefertothesectionOperation

ofCurrentDevicefordetails.

Intheeventthatthepowersupply

cordisdamaged,itcannotbe

repaired-itmustbereplacedwitha

cordfromtheProductManufacturer.

Donot,underany

circumstances,cut,

remove,orbypass

thegroundingprong.

Powersupplycord

with3-pronggroundingplug

andcurrentdetectiondevice

Operationof Cur rentDevice

(Applicabletotheunitadoptscurrentdetectiondeviceonly)

Thepowersupplycordcontainsacurrentdevicethatsensesdamagetothepowercord. Totestyourpower

supplycorddothefollowing:

1.Pluginthe AirConditioner.

2. Thepowersupplycordwillhave TWObuttonsontheplughead.Pressthe TEST button,youwillnoticea

clickastheRESET buttonpopsout.

3.PresstheRESET button,againyouwillnoticeaclickasthebuttonengages.

4. Thepowersupplycordisnowsupplyingelectricitytotheunit.(Onsomeproductsthisitalsoindicatedby

alightontheplughead.)

Donotusethisdevicetoturntheunitonoroff.

AlwaysmakesuretheRESET buttonispushedinforcorrectoperation.

Thepowersupplymustbereplacedifitfailsresetwheneitherthe TEST buttonispushed,oritcannotbe

reset. A newonecanbeobtainedfromtheproductmanufacturer.

Ifpowersupplycordisdamaged,itcannotberepaired.ItMUST bereplacedbyone

NOTES:

obtainedfromthe

productmanufacturer.

Please refer to the section “Operation

of Current Device” for details.

Cooling operation

Outdoor Temp: 64.4-109.4°F (18-43°C) (T

Environment) 69.8-125.6°F (21-52°C) (T

Environment)

Indoor Temp: 62.6-89.6°F (17-32°C) (T

Environment) 62.6-89.6°F (17-32°C) (T

Environment)

Heat operation

Outdoor Temp: 23.0-75.2°F (-5-24°C) (T

Environment) 19.4-75.2°F (-7-24°C) (T

Environment)

Indoor Temp: 32.0-80.6°F (0-27°C) (T

Environment) 32.0-86.0°F (0-30°C) (T

Environment)

www.nitropdf.com

Downloaded from www.ManualsFile.com manuals search engine

Loading ...

Comfort Aire RADS-51J Room Air Conditioner

Owner’s Manual - Page 5