Loading ...
Loading ...
Loading ...
![](https://files.manualsfile.com/29874534-24k2vr-17s-ja-i-o/bgd.png)
13
v.03062023
Drill Wall Hole
NOTE:
• Make sure there is no building structure pillar, beam, strut, or any electrical wire, or water pipes in the way of the drill hole.
• Always insert the sleeve into the wall hole and seal the surrounding with putty if you are installing it on a hollow wall such as drywall
or plaster walls. This will prevent water, insects, or small animals from getting into the wall.
1. Pick 1 of the 3 piping positions on your air conditioner.
2. Mark a Ø70mm hole that goes from the indoor wall to the outdoor wall. The hole must be slanted
downward with a small angle. And the position of the hole must be lower than the indoor unit
drainage port.
3. Drill the hole and insert the wall sleeve (not included) and sleeve cover into the hole.
Right side of the unit
Piping Position
Left side of the unit
Indoor
5 - 10mm
Outdoor
Behind of the unit
• Drilling into electrical wires or water pipes inside the wall may cause electric shock, re, or
water damage.
WARNING
Indoor Unit Installation
Ø70mm hole
Loading ...
Loading ...
Loading ...