Loading ...
Loading ...
Loading ...
10
DEUTSCHENGLISH FRANCAIS
ESPAÑOL
POLSKI ITALIANO
简体中文 繁體中文
19
BATTERY CHECK
Button for displaying battery status with the status LEDs (No. 20).
20
BATTERY STATUS LEDs
4-segment LED battery status display. Press button no. 19 for display of battery status by the status LEDs. If all 4 LEDs light up, the battery is fully
charged. If only the red LOW LED is lit, charge the battery immediately, or exchange it for a fully charged battery.
21
CHARGE
The battery in the corresponding column section is charged and the CHARGE LED lights up as soon as the speaker system is correctly connected to the power sup-
ply (a separate charging dock is optionally available). The battery is also charged if the speaker system is connected to the mains power supply, but is switched
off (OFF/CHARGE). The charge current is 2.5 A. If the speaker system is switched on, the charge current is 1.5 A. Charging time when the system is switched-off (OFF/
CHARGE) is approximately 3 hours. When full charge voltage is reached, the charging process is automatically stopped and the CHARGE LED goes out. The charging
system checks the battery voltage at regular intervals and automatically restarts the charging process if full charge voltage (as dened in the charging system)
is not achieved.
STANDBY MODE
The MAUI5 GO (100) loudspeaker system features a standby mode that is activated if no input signal is detected for about 15 minutes. The loud-
speakers are muted and the PROTECT LED begins to ash. If a signal is present, the system automatically returns to normal operating mode, the
speakers are unmuted and the PROTECT LED stops ashing. Signal detection occurs before the MAIN LEVEL control.
19
20
21
16
SYSTEM OUTPUT
Balanced line output with male XLR socket for connecting to other MAUI5 GO (100) speaker systems.
17
POWER SOCKET AND FUSE HOLDER
IEC mains socket with built-in fuse holder. A suitable power cable is included.
IMPORTANT: Replace the fuse only with a fuse of the same type and value. Follow the instructions printed on the housing. In the event of repeated
fuse failure, please contact an authorised service centre.
18
POWER ON-OFF/CHARGE
This switch does not disconnect the system from the power supply in any position. Secure all-pole disconnection is only achieved by
removing the mains plug. The system is ready to use in the ON position, either operating on batteries without an external power supply or,
if an external power supply is available, regardless of the battery charge level. The system is switched off in the OFF/CHARGE position,
but the battery will charge if connected to the mains.
Loading ...
Loading ...
Loading ...