Loading ...
Loading ...
Loading ...
For Quick-Connect Wands:
Spray Nozzles
Your pressure washer is equipped with up to five
spray nozzles. Each nozzle is color coded and deliv-
ers a specific spray pattern for a particular cleaning
purpose. The size of the nozzle determines the size
of the fan spray and the pressure out of the nozzle.
The 0°, 15° , 25°, and 40° nozzles are high pressure
nozzles. The chemical nozzle is a low pressure noz-
zle.
The nozzles are housed in
receptacles on the panel of
the pressure washer handle.
Color squares on the panel
identify nozzle location and
spray pattern.
_WHEN USING THE HIGH
PRESSURE NOZZLES,
DO NOT ALLOW THE JET=LIKE SPRAY TO
COME IN CONTACT WiTH UNPROTECTED
SKIN, EYES, OR WITH ANY PETS OR ANk
MALS. SERIOUS INJURY CAN OCCUR.
0° nozzle - Red. This nozzle delivers a pinpoint
stream and is extremely pow-
erful. It covers a very small
area of cleaning. This nozzle
should only be used on sur-
faces that can withstand this
high pressure such as metal or
concrete. Do not use on
wood.
15° nozzle - Yellow. This
nozzle delivers a powerful 15
degree spray pattern for
intense cleaning of small
areas. This nozzle should only
be used on areas that can
withstand the high pressure
from this nozzle.
25° nozzle - Green. This
nozzle delivers a 25 degree
spray pattern for intense
cleaning of larger areas. This
nozzle should only be used on
areas that can withstand the
pressure from this nozzle.
40° nozzle - White. This noz-
zle delivers a 40 degree spray
pattern and a less powerful
stream of water. It covers a
wide area of cleaning. This
nozzle should be used for
most general cleaning jobs.
Chemical nozzle - Black. This nozzle is used to
apply chemicals or cleaning solutions. It has the least
powerful stream.
Changing Nozzles
DO NOT attempt to
change nozzles while
pressure washer is running. Turn engine
off before changing nozzles.
1. Pull quick connect coupler
back and insert nozzle.
2_
Release quick connect
coupler and twist nozzle to
make sure it is secure in
coupler.
HOW TO SIPHON
CHEMICALS/CLEANING SOLVENTS
Siphoning chemicals or cleaning solvents is a low
pressure operation.
NOTE: Use only soaps and chemicals designed for
pressure washer use. Do not use bleach.
To siphon chemicals:
1. Press chemical hose onto
barbed fitting located near
high pressure hose connec-
tion of pump as shown.
2. Place other end of chemical
hosewithfilteronitinto
container holding chemi-
cal/cleaning solution.
3. On multi-reg:
Set multi-reg nozzle to low
pressure setting, see How
To Use Wand paragraph in
this section.
On quick connect wand:
Install low pressure (black)
nozzle into quick connect
fitting of wand, see How To
Use Wand paragraph in this
section.
4. After use of chemical,
siphon clean water through
chemical hose to rinse it
and pump clean. Chemicals
which remain in pump can
damage it. Damage to pump due to chemicals will
not be covered under warranty.
NOTE: Chemicals and soap will not siphon when
using high pressure nozzles.
11 -- ENG
Loading ...
Loading ...
Loading ...