Loading ...
Loading ...
Loading ...
7
Electrical Installation
All installation must be carried out by a competent person or qualified electrician. Before
connecting the mains supply ensure that the mains voltage corresponds to the voltage on the
rating plate.
Direct Connection
The appliance must be connected directly to the mains using an omnipolar circuit breaker with
a minimum opening of 3mm between the contacts.
The installer must ensure that the correct electrical connection has been made and that it
complies with the wiring diagram.
The cable must not be bent or compressed.
Regularly check the power plug and power cord for damage. If the supply cord is damaged, it
must be replaced by a special cord or assembly available from the manufacturer or its service
agent.
WARNING: This is a Class I appliance and MUST be earthed
This appliance is supplied with a 3 core mains cable coloured as follows:
Brown = L or Live
Blue = N or Neutral
Green and Yellow = E or Earth
HINTS FOR EXHAUST DUCT INSTALLATION
The following rules must be strictly followed to obtain optimal air extraction:
• Keep expansion pipe short and straight.
• Do not reduce the size or restrict the expansion pipe.
• When using the expansion pipe always install the pipe pulled taut to minimize
pressure loss.
• Failure to observe these basic instructions will reduce the performance and increase
noise levels of the cooker hood.
• Any installation work must be carried out by a qualified electrician or competent
person.
•Do not connect the ducting system of the hood to any existing ventilation system
which is being used for any other appliance ,such as warmer tube, gas tube , hot wind
tube.
•The angle of the bend of the expansion pipe should not be less than 120º; you must
direct the pipe horizontally, or, alternatively, the pipe should go up from the initial point
and should be led to an outer wall.
Loading ...
Loading ...
Loading ...