Loading ...
Loading ...
Loading ...
INSTALLATION INSTRUCTIONS
Excessive Weight Hazard
Use two or more people to move and installicemaker.
Failureto do so can resultinback or other injury.
Removing Packaging Materials
Remove tape and glue from your ice maker before using.
• To remove any remaining tape or glue from the exterior of the
ice maker, rub the area briskly with your thumb. Tape or glue
residue can also be easily removed by rubbing a small
amount of liquid dish soap over the adhesive with your
fingers. Wipe with warm water and dry.
• Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. Do not
use chlorine bleach on the stainless steel surfaces of the ice
maker. These products can damage the surface of your ice
maker.
Cleaning Before Use
After you remove all of the packaging materials, clean the inside
of your ice maker before using it. See the cleaning instructions in
the "Ice Maker Care" section.
• TO ensureproperventilationforyouricemaker,thefrontside
must be completelyunobstructed.The icemaker may be
dosed-in on thetop and threesides,butthe installation
shouldallowthe icemaker tobe pulledforwardforservicing
ifnecessary.
• Installationoftheicemaker requiresacoldwatersupplyinlet
ofV4"(6.35ram) OD softcopper tubingwitha shutoffvalve
and eithera gravity-drainsystem orcondensate pump to
carrythe watertoan existingdrain.
• Choose a wellventilatedareawithtemperaturesabove 55°F
(13°C)and below 110°F (43°C).Bestresultsareobtained
between 70°F (21°C)and 90°F (32°C).
The ice maker must be installed in an area sheltered from the
elements, such as wind, rain, water spray, or drip.
When installing the ice maker under a counter, follow the
recommended opening dimensions shown. Place electrical
and plumbing fixtures in the recommended location as
shown.
NOTES:
• Be sure the power supply cord is not pinched between
the ice maker and the cabinet.
• Be sure the water supply line is not pinched between the
ice maker and the cabinet.
• Be sure the drain line (on some models) is not pinched
between the ice maker and the cabinet.
34"
(86.4 cm)
Min.
341/2''
(87.6 cm)
Max.
281/2,,
(72.4 cm)
cm)
}"_ 15"
(38.1 cm)
A.Recommended location for electrical
and plumbing fixtures
B.Floor level
A
B
Choose a location where the floor is even. It is important for
the ice maker to be level in order to work properly. If needed,
you can adjust the height of the ice maker by changing the
height of the leveling legs. See "Leveling."
Loading ...
Loading ...
Loading ...