Loading ...
Loading ...
Loading ...
11 / EN
Washer-Dryer / User Manual
DANGER!
• Your product is heavy. Remove packaging
reinforcement as displayed in the figure.
• Be careful not to get your hand caught
under the machine during this procedure.
3.3 Removing the transit bolts
A
PRECAUTION!
• Do not remove the transit bolts before
removing the packaging reinforcement.
• Remove the transit bolts before operating
the washing machine! Otherwise, the
product will get damaged.
1
1 Use a tool to
loosen all bolts until
they rotate freely.
2
2 Remove the transit
bolts by turning
them slightly.
3
3 Attach the plastic
covers supplied in
the user manual
bag into the holes
on the rear panel.
C
INFORMATION
• Keep the transit bolts in a safe place to
reuse when the product needs to be
moved again in the future.
• Never move the product without the transit
bolts properly fixed in place!
3.4 Connecting water supply
C
INFORMATION
• The water supply pressure required to run
the product is between 1 to 10 bars (0.1
– 1 MPa). It is necessary to have 10 – 80
liters of water flowing from the fully open
tap in one minute to have your product run
smoothly. Attach a pressure reducing valve
if water pressure is higher.
A
CAUTION!
• Models with a single water inlet should not
be connected to the hot water tap. In such
a case the laundry will get damaged or the
product will switch to protection mode and
will not operate.
• Do not use old or used water inlet hoses
on the new product. It may cause stains on
your laundry.
1
1 Connect the special
hose supplied
with the product
to the water inlet
on the product.
A
CAUTION!
• Ensure that the cold water connection is
made correctly when installing the product.
Otherwise, your laundry will come out hot
at the end of the washing process and
wear out.
2
2 Tighten the hose
nuts securely
by hand. Never
use a tool when
tightening the nuts.
Loading ...
Loading ...
Loading ...