Loading ...
Loading ...
Loading ...
Apollo Twin X Hardware Manual Controls & Connectors 23
(3) Channel Selection Indicators
The currently selected input channel is indicated by the lit channel name above its input
meter (CH1 or CH2). Press the PREAMP button (7) to switch between channels 1 & 2.
(4) Input Meters
The two input meters display signal levels for each of the analog input channels. Reduce
a channel’s preamp gain (see Set Input Gains) if its red clip LED illuminates.
(5) Input Source Indicators
These indicators show which input source jack (MIC, LINE, or HI-Z) is active for the
selected input channel. Use the Input Select button (13-a) to switch between the
MIC (XLR) and LINE (¼”) rear panel combo jack inputs. The Hi-Z input is selected
automatically when an instrument cable is plugged into the Hi-Z jack on the front panel.
(6) Talkback Microphone
The built-in talkback mic is located inside of this hole. The talkback function is
configured in the companion Console software and can be activated with the TALK
button (13-g) when Monitor mode is active.
Caution: The talkback microphone is sensitive. To avoid equipment damage, do
not insert any object into the mic hole, apply pressurized air into the mic hole, or
use a vacuum over the mic hole.
(7) PREAMP Button
Press this button to enter PREAMP Mode and activate the input channel controls. Press
again to alternate the selected input channel (3) between CH1 and CH2.
(8) MONITOR Selected Indicator
When MONITOR is lit, the Level knob (1) controls volume of the monitor outputs (16).
Press the MONITOR button (11) to activate the monitor controls (you may need to press
it more than once).
Note: The MONITOR indicator is RED when the monitor outputs are muted.
(9) Stereo Output Meters
These meters display the main stereo signal output bus levels.* The main output bus
levels are independent of monitor and headphone volume levels. Reduce levels feeding
the output(s) if a red “C” (clip) LED at the top of the Output Meters illuminates.
*Exception: If HEADPHONE is currently selected on Apollo Twin X and the
Headphone Source within the CUE OUTPUTS window in Console is set to HP,
these output meters indicate the level being sent to the headphone bus via
Console’s headphone sends and/or the DAW.
Loading ...
Loading ...
Loading ...