Loading ...
Loading ...
Loading ...
6
Installation Preparation
OPTIONAL - HARD WIRING PRIOR TO INSTALLATION - CONTINUED
IMPORTANT: Ensure
house wires are routed
UNDERNEATH all other
harness wiring from the
electronics module.
8
9
10
11
12
13
14
3
TERMINATE HOUSE WIRING AS SHOWN AND REPLACE MODULE AND COVERS
8 Fit a suitable cable clamp for the
conduit through the metal knockout.
Ensure wiring is routed through or
under housing ribs.
9 Screw down the Live, Neutral and
Ground wires correctly.
10 Push the plastic harness cover back
over. It should clip back into place
11 Fold down and slide back the
terminal block cover.
12 Refit the electronics module back
into position, being careful of wiring.
13 Replace the screw securing the
electronics module.
14 Slide the access cover back,
ensuring the 2 clips shown are fully
locked in place.
NOTE: Use copper conductors only.
9
IMPORTANT: Both ring terminals must be
replaced and the bare Ground wire clamped
If house wiring is not 2-wire with ground, a ground must be provided by the installer.
When house wiring is aluminum, be sure to use UL-Listed anti-oxidant compound
and aluminum-to-copper connectors.
WARNING
Si el cableado doméstico no cuenta con un cable de 2 hilos con conexión a tierra,
un instalador debe realizar una conexión a tierra. Cuando el cableado doméstico
es de aluminio, asegúrese de usar un compuesto antioxidante y conectores de
aluminio a cobre aprobados or UL.
ADVERTENCIA
Loading ...
Loading ...
Loading ...