Loading ...
Loading ...
Loading ...
• Open the fuel cap slowly so that any excess
pressure is released gently when you refuel.
• Tighten the fuel cap carefully after you refueled.
• Clean the area around the fuel cap. Contamination in
the tank can cause operating problems.
• Always move the product 3m (10ft) or further from
the refuelling area and source before starting.
Safety instructions for maintenance
WARNING: Always stop the engine before
you do any work on the cutting attachment.
The cutting attachment continues to rotate
even after the throttle has been released.
Ensure that the cutting attachment has
stopped completely and disconnect the
spark plug before you start to work on it.
WARNING: A faulty cutting attachment may
increase the risk of accidents.
WARNING: Make sure that the trimmer cord
is wound tightly and evenly around the
drum, otherwise the product will generate
harmful vibration.
• Only use cutting attachments with the guards we
recommend. Refer to
Accessories on page 26
.
Assembly
Introduction
WARNING: Before you assemble the
product, you must read and understand the
safety chapter.
WARNING: Remove the spark plug cable
from the spark plug before you assemble the
product.
To assemble the loop handle (525LST,
525RJD)
1. Attach the loop handle onto the shaft between the
arrows.
2. Install the spacer into the slot of the loop handle.
3. Attach the nut, the knob and the screw. Do not make
it too tight.
4. Adjust the product to a correct work position.
5. Tighten the bolt.
To assemble the J-handle (525LST,
525RJD)
WARNING: Do not use saw blades with the
J-handle.
1. Attach the J-handle to the loop handle with 3 screws.
Do not tighten the screws fully.
2. Adjust the product to a comfortable position.
3. Tighten the screws.
10 1363 - 001 - 25.10.2019
Loading ...
Loading ...
Loading ...